What it is and how much
Material type, depth and area, because that sets both the volume and the handling.
Some attics need clearing before anything new goes in. Covering wet, contaminated or settled material traps whatever caused it and hides it somewhere nobody will look again for years.

Family ownedOperating since 2010
Spray foam specialistsNot a general insulation reseller
Two crews, two statesNorth Georgia and North Alabama
Lawrenceville based1891 Prospect Church Road

Not every attic needs clearing. Dry, clean, simply thin insulation can often stay and be added to. These are the cases where it cannot.
Removal is mostly a logistics job. Getting the material out without bringing it through your living space is the hard part.
Material type, depth and area, because that sets both the volume and the handling.
How it leaves the attic and the building. We plan containment so it does not travel through finished space.
If moisture or pests put the material in that condition, the cause gets identified. Replacing insulation without fixing the cause just resets the clock.

Removal is almost never the whole job. It is the step that makes the real work possible.


The goal is that the only evidence we were there is a clean attic.
Material, volume, route out and the protection needed for the space below and the path through it.
If water or pests did this, that gets named. Sometimes the fix is ours and sometimes it is not. We will say which.
Out of the attic, out of the building and disposed of properly.
The deck or the ceiling plane left ready for the new work.
The things owners usually want settled before they book an estimate.
No. If it is dry, clean and simply thin, it can often stay and be added to, and that saves you money. Removal is for material that is wet, contaminated, pest damaged, fire affected or so settled that it no longer does anything. We will tell you honestly which situation you are in.
That is the part we plan first. The route out and the containment get decided before anything is disturbed, specifically so the material does not travel through your finished space.
We can, but it is worth asking why. If the attic is being cleared because of a leak or an infestation, the cause needs addressing, and leaving the attic bare afterwards has its own consequences. We would rather plan both steps together.
We remove the contaminated material and we will tell you where they are getting in if we can see it. Actually treating an infestation is a pest control job, and we would rather send you to someone who does that properly than pretend it is our trade.
It depends on the material, the volume, the access and the containment needed. Access is usually the biggest factor, not the square footage. We quote it after looking in the attic.
Send us a photo or book the estimate. We will tell you straight either way.